1.40 STUDING FEED BACK

[RX-1PRO]

HAS ANYBODY STUDED THERE 121 RIPSAW DOWN THE MIDDLE WITH 144 (1.40) STAINLESS STEEL ??? OR WILL THESE HIT SOME THANG??? AND WHAT IS THE BEST PATTERN TO RUN FOR THE MIDDLE?? ??

 

[sxviperfan]

217 STUDS IS THE WAY TO GO.LOL.

 

[RX1Maine]

I used Woody's Gold Diggers 1.325 and 144 down the middle and have never had a problem. I make up my own jig. I don't know if I would go with anything bigger than the 1.325

 

[rxbrent]

studs

I went with the 1.40 extreme max studs. I have 1800 miles on them with no issues.

 

[rx1sledneck]

Ihave 192(1.40) on double backers.All down the center. I put a small hole in my heat exchanger. I real it was my fault doto the fact that my track was a little loose and my heat exchanger was bent.Oh ya that was after about 2200 miles. I have very few studs in poor condition

 

[pro116]

extreme 1.40 are the same size as woddy's 1.325

 

[RX-1PRO]

THANKS

THANKS GUYS. (217 GET REAL IN A 121)

 

[4Fighter]

I don't know if this is because of the Expert-X or not but I installed 162 1.325" up the center on my 136" Ripsaw, and ended up pulling my track to install 1/4" X 1" alum. strips. I was pretty lucky as I only scratched the front cooler, and heat shield.

WORD TO THE WISE