Sugarkryptonite
Veteran
Hi guys
Did a rebuild of my Fox floats today. New oil and took out a couple of shims on both compression and rebound side to try to get them softer. It didn’t seem to make any difference at all. They are still hard as hell!
Can anyone tell me what the IFP is suppose to be? Also how to measure it exactly? I don’t think I did it properly but I put back in the same anount of oil that I took out. Does the seal for the nitrogen port need to be removed first before putting the stack back in?
Just wondering if it was me putting it back together properly that is making them hard or the stacks still need to be revised
Did a rebuild of my Fox floats today. New oil and took out a couple of shims on both compression and rebound side to try to get them softer. It didn’t seem to make any difference at all. They are still hard as hell!
Can anyone tell me what the IFP is suppose to be? Also how to measure it exactly? I don’t think I did it properly but I put back in the same anount of oil that I took out. Does the seal for the nitrogen port need to be removed first before putting the stack back in?
Just wondering if it was me putting it back together properly that is making them hard or the stacks still need to be revised
