YukonKing
Newbie
- Joined
- Mar 13, 2021
- Messages
- 7
- Reaction score
- 2
- Points
- 93
- Location
- Yukon
- Country
- Canada
- Snowmobile
- 2007 Venture MP
Here was my process,
2018 VK Pro, EPS, 13,000 kms
- slow to crank, worse in the cold,
- no start, found starter electrically "open"
- tappy tappy and spun it backwards, would crank but still slow
- next no start decided to change starter......this is what I found.
Oil in starter, pinion shaft oil seal failed starter full of oil. Brushes worn, burned, corroded.
Removed : secondary clutch, oil tank and filter, air box, battery and craddle, 1 long rear engine mount bolt, 2 front engine mount bolts, steering rack shifted to one side. This gave enough room to remove engine up and pull starter through oil filter access plate hole.
2018 VK Pro, EPS, 13,000 kms
- slow to crank, worse in the cold,
- no start, found starter electrically "open"
- tappy tappy and spun it backwards, would crank but still slow
- next no start decided to change starter......this is what I found.
Oil in starter, pinion shaft oil seal failed starter full of oil. Brushes worn, burned, corroded.
Removed : secondary clutch, oil tank and filter, air box, battery and craddle, 1 long rear engine mount bolt, 2 front engine mount bolts, steering rack shifted to one side. This gave enough room to remove engine up and pull starter through oil filter access plate hole.
