Another under tunnel exhaust

[radianguy]

Well I wanted to do this to my Nytro since I first got it but could not tear into a new sled, so now that I have 2 winters under it it was time to make a few changes. This fall when I started my annual maintenance I had it tore down to replace the exhaust gaskets so I decided to do the under tunnel exhaust.

Here are a few pics so far, I'll post some more when it's complete and on the snow!

 

[sleddheadd]

Cool! Keep the pics and info. coming! What kind of exhaust are you putting on there?

 

[radianguy]

Everyone I tell laughs, but it is a Cherry Bomb with a baffle I made to tone it down. I think it is a bit quieter than the MBRP I had but I won't know for sure until I get it out on the snow.

 

[radianguy]

I haven't been able to spend much time at the sled lately work has been crazy but I took this weekend to finish it up! All I need to do now is put the plastic back on. I put my MTX skis on today and found that my ball joints are gone again, had them replaced at 5000km, going to see the dealer tomorrow.

We have been getting a bit of snow in the last week, hopefully I'll soon be able to get some pics on the snow!

I should have all bases covered this year!

 

[sonds]

Boy those CL's fit nice

 

[radianguy]

We finally got some snow so I had to haul the sled out for a rip after work today! Gotta say it was nice!!

 

[bagadonitz]

How much snow did you get in those parts today?

 

[radianguy]

What you see! Had none this morning when I went to work. More in the higher terrain, about 4-6 inches around town. If this keeps up will have no trouble to go for a real ride the weekend. Guys are heading in tomorrow, will know more then!

 

[Gone Blue]

The Rev gas tank and the rack look good on the back of your XTX. However it looks like the brake light sits below the top of the gas tank. I would l install one of the slim LED brake lights on the back of the rack. G.B.

 

[radianguy]

I think the light will work better here than it did on the tail because it would snow over and you could not see the light. I wanted to put an LED out back, but figured I would try this. The light is very bright and no trouble to see from behind, I think it will be ok!