1. We are no longer supporting TapaTalk as a mobile app for our sites. The TapaTalk App has many issues with speed on our server as well as security holes that leave us vulnerable to attacks and spammers.
    Dismiss Notice

Apex with a 2.6 powerclaw

Discussion in 'Apex Mountain' started by Sledder Joe, Jun 16, 2018.


  1. Sledder Joe

    Sledder Joe Newbie

    Messages:
    5
    Location:
    Yakima
    Country:
    USA
    Snowmobile:
    2008 Apex MTX
    So I'm switching to a 162x15x2.6 powerclaw on my 08 Apex. Rails are a good fit but my 7 tooth drivers don't seem to engage the track correctly. Has anyone done the changeover? If so what drivers did you use? :sled1:
     
  2.  
  3. zx4ever

    zx4ever Pro

    Messages:
    147
    Location:
    Northern BC canada
    Country:
    Canada
    Snowmobile:
    08 nytro ty4stroke customized
    Avid has the ones you need. I tried stock but then after the did not fit right I contacted Robbie at avid.
     
  4. Sledder Joe

    Sledder Joe Newbie

    Messages:
    5
    Location:
    Yakima
    Country:
    USA
    Snowmobile:
    2008 Apex MTX
    I sent Avid an email. Any chance arctic cat drivers would have the same hex shaft diameter?
     
  5. zx4ever

    zx4ever Pro

    Messages:
    147
    Location:
    Northern BC canada
    Country:
    Canada
    Snowmobile:
    08 nytro ty4stroke customized
    I don’t think it’s the same but they make one for it to fit the power claw track on the Yamaha shaft
     
  6. princesledalot

    princesledalot Expert

    Messages:
    208
    Location:
    East Pouce
    Country:
    Canada
    Snowmobile:
    04 RX1 13 apex se 96 vmax 4 aerocharged
    LOCATION:
    Pouce Coupe BC
    Will avid drivers for an apex work on the viper track?
     
  7. maim

    maim Moderator Staff Member Moderator Lifetime VIP Member VIP Member

    Messages:
    4,785
    Location:
    sudbury on
    Country:
    Canada
    Snowmobile:
    2016 apex xtx/ 2011 apex xtx/ 2009 phaser rtx/x/ 1997 et410t/r
    you have to check the driver pitch to make sure they are the same. i know the apex mtx are 3 pitch stock.
     
  8. princesledalot

    princesledalot Expert

    Messages:
    208
    Location:
    East Pouce
    Country:
    Canada
    Snowmobile:
    04 RX1 13 apex se 96 vmax 4 aerocharged
    LOCATION:
    Pouce Coupe BC
    the pitch is the same at 3 inches but the outside lugs on the older style of drivers need to be cut off as the track has little bumps that cause the lugs to climb over them.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice