Sledder Joe
Newbie
So I'm switching to a 162x15x2.6 powerclaw on my 08 Apex. Rails are a good fit but my 7 tooth drivers don't seem to engage the track correctly. Has anyone done the changeover? If so what drivers did you use?
zx4ever
VIP Member
- Joined
- Apr 14, 2011
- Messages
- 317
- Location
- Northern BC canada
- Country
- Canada
- Snowmobile
- 08 nytro ty4stroke customized
Avid has the ones you need. I tried stock but then after the did not fit right I contacted Robbie at avid.
Sledder Joe
Newbie
I sent Avid an email. Any chance arctic cat drivers would have the same hex shaft diameter?
zx4ever
VIP Member
- Joined
- Apr 14, 2011
- Messages
- 317
- Location
- Northern BC canada
- Country
- Canada
- Snowmobile
- 08 nytro ty4stroke customized
I don’t think it’s the same but they make one for it to fit the power claw track on the Yamaha shaftI sent Avid an email. Any chance arctic cat drivers would have the same hex shaft diameter?
princesledalot
Expert
- Joined
- Feb 8, 2006
- Messages
- 226
- Age
- 52
- Location
- East Pouce
- Country
- Canada
- Snowmobile
- 04 RX1 13 apex se 96 vmax 4 aerocharged
- LOCATION
- Pouce Coupe BC
Will avid drivers for an apex work on the viper track?
- Joined
- Jun 1, 2004
- Messages
- 7,692
- Location
- sudbury on
- Country
- Canada
- Snowmobile
- 2016 apex xtx
2011 apex xtx
2009 phaser rtx/x
1997 et410t/r
1988 vk 540
you have to check the driver pitch to make sure they are the same. i know the apex mtx are 3 pitch stock.
princesledalot
Expert
- Joined
- Feb 8, 2006
- Messages
- 226
- Age
- 52
- Location
- East Pouce
- Country
- Canada
- Snowmobile
- 04 RX1 13 apex se 96 vmax 4 aerocharged
- LOCATION
- Pouce Coupe BC
the pitch is the same at 3 inches but the outside lugs on the older style of drivers need to be cut off as the track has little bumps that cause the lugs to climb over them.
Similar threads
- Replies
- 4
- Views
- 777
- Replies
- 2
- Views
- 681