krauss2005
Extreme
how high can i go wit hthe bars without cable extensions?
2 inches for sure, 3 inches if you reroute the cables and brake line. I have a 2" articulating riser that is rotated fully forward. With that, I could have easily went with 3-1/2 so that it would have been forward the same amount but up a little higher.
Highmiler
Expert
riser
I think the height you are able to put is dependent on how much you want to move the bars forward. I have a powermadd pivot riser(1.25inches), and a 2inch riser block giving me a total of 3.25 inches. I adjusted the riser block all the way forward. then adjusted my bars upright accordingly. After all was said and done the bars ended up moving forward 2inches and up 2 inches. Cables are long enough for this setup, and if you want your sled to be more like a Nytro, Apex, this is where you want to put them. On the other side of the coin let's say I wanted to adjust my bars in a pull back position(like riding a Harley), and I adjust them to go up 2 inches and back 2inches, I wouldn't have enough cable length. Hope this helps.
I think the height you are able to put is dependent on how much you want to move the bars forward. I have a powermadd pivot riser(1.25inches), and a 2inch riser block giving me a total of 3.25 inches. I adjusted the riser block all the way forward. then adjusted my bars upright accordingly. After all was said and done the bars ended up moving forward 2inches and up 2 inches. Cables are long enough for this setup, and if you want your sled to be more like a Nytro, Apex, this is where you want to put them. On the other side of the coin let's say I wanted to adjust my bars in a pull back position(like riding a Harley), and I adjust them to go up 2 inches and back 2inches, I wouldn't have enough cable length. Hope this helps.
