AftonJay
Extreme
- Joined
- Oct 23, 2012
- Messages
- 103
- Reaction score
- 18
- Points
- 718
- Location
- Northern Michigan
- Country
- USA
- Snowmobile
- 2005 Warrior, 2009 Nytro XTX and Arctic cat puma for the kids
- LOCATION
- Afton Mi
Hi guys, I bought a 2005 RX warrior this summer and we finally got some snow and it trouble starting and ran pretty rough so i took many of your advice and cleaned the carbs. The starter jets appeared to all be clogged. Anyways i want to replace the main jet o-rings, and the gaskets is there any reasonable priced place to get these? Adding it up from my dealer i am looking at about 60 bucks just for the two main jet o-rings and the gaskets which seem a little high. Thanks
wpgwarrior
Expert
rings
i have extras jay...pm me your address and i will mail them to you if you wish.
i have extras jay...pm me your address and i will mail them to you if you wish.
thobkirk
Extreme
I bought my new orings from the hardware store. Cost me $2.
AftonJay
Extreme
- Joined
- Oct 23, 2012
- Messages
- 103
- Reaction score
- 18
- Points
- 718
- Location
- Northern Michigan
- Country
- USA
- Snowmobile
- 2005 Warrior, 2009 Nytro XTX and Arctic cat puma for the kids
- LOCATION
- Afton Mi
what about the upper one on the main jet holder? The one in the middle, not the one that seals it to the float bowl. Mine looks like it is a cone or wedge shape
thobkirk
Extreme
I didn't have to replace those. Just the ones between the jets and the bowls . You may have to go though yamaha for those.
grader
TY 4 Stroke Master
you can run without them just fine, they were put there for the mountain sleds. mine were removed years ago after they cemented themselves to the bowl, making it very hard to remove.
