couple slider questions

[steiner]

I think I may have them on there now. Is there an X design on the wheel? I will check them with a caliper, I bought it used a few years ago

The X wheels from Excel are 135.8mm.
What I like about the Poo/Doo combo or the Pioneer Perf drop kit is that the wheel mounts are a 2 bolt mount verses the single factory bolt.

 

[renegademan17]

Almost done rebuilding skid on my 07 Attak new hygear shock revalve all around and spring kit and went with the duponts and Excel wheels but am a little worried now that I hear they may crack the rails due to increased pressure. I am studded but only on the center of track. Most of my riding is breaking trail on logging roads with trail use also. I guess time will tell?
Is Pioneer out of business?

 

[steiner]

Holy thread resurrection!
Get the BoP reinforcement kit for the rails.

 

[tedgoesfast]

What I do is put wheels of a 1992 indy 500 on mine take out plastic inserts and they fit saves slides you would have to buy 6 only 26 dollars each locktight bolts though as the bearing is a bit thicker also dupount slides

 

[SumpBuster]

I have found the slides wear down quickly (Had 2 sets of little wheels, and removed them. Remember to needle grease them as they spin lots more revolutions than thier big brothers and wear the bearings, which are small too). bottom line, when that little rib on the slides is gone, and scratching it sounds paper thin, I replace. After the initial wear down, I go thousands of miles on worn slides.

 

[renegademan17]

Holy thread resurrection!
Get the BoP reinforcement kit for the rails.

I know I like to bring back the dead! BTW what is the BoP kit?

 

[steiner]

I know I like to bring back the dead! BTW what is the BoP kit?

http://www.barnofparts.com/rail-savers-for-136-mono

 

[viper7mi]

I started with the stock Yamaha spoke wheels, then I added the small wheel kits at the bend and the middle. The kits helped, but what works is the Pioneer drop down kit. Stopped hifax wear.