Dzus fasteners-no more damn screws

[BigDogrx1]

Just put the DZUS 1/4 turn During fasteners on side cover of RX1.
came out with nice tight fit. Can't wait to not fight with them damn screws anymore. Used 17mm and were great fit a couple needed 2 washers was all.

 

[superfan75]

That looks like a great idea to make removing the panels. I might have to copy you.

 

[BigDogrx1]

Thanks super, real nice just grab during and 1/4 turn out and your done.
HATE THEM SCREWS
Bought off eBay 17mm pins

 

[superfan75]

Yeah those screws are a PIA.

 

[couch]

Gotta love the genius who though that it would be a great idea to use three different types of fasteners on the side panels of the phazers!!!

 

[Sasquatch]

Nice but I never really worried about the screws as the panels only come off once a year in the warm garage. I just wish my Apex had the lift hood. Hate the Dzus fittings in the cold so I don't check my oil on the trail. Or my belt!

 

[BigDogrx1]

Nice but I never really worried about the screws as the panels only come off once a year in the warm garage. I just wish my Apex had the lift hood. Hate the Dzus fittings in the cold so I don't check my oil on the trail. Or my belt!

GOOD

 

[TOMBOB]

Good job Larry was it a easy job, can this old fart do it

 

[BigDogrx1]

Tom each side is about 1/2 hour.
But I used the rivet style backs.
They also have slide on clips, but I had a couple tear outs in plastic.
If your plastic is good-just remove old screw clip and replace with Dzus clip.

 

[Lagman]

Hey Big Dog! I know this is old but where'd you get them and did you just take the threaded parts out and rivet them in the same spot where they were. Can't really see the back of the female.
Thanks