RacinJason15
Expert
- Joined
- Jan 23, 2008
- Messages
- 253
- Reaction score
- 50
- Points
- 858
- Location
- Comstock Park, MI
- Country
- USA
- Snowmobile
- 17' Yamaha Sidewinder LTX DX
- LOCATION
- Comstock Park
I have my innovate lc-2 wideband air fuel gauge hooked up and I can get the gauge to connect, BUT.... Can't get it to display the actual readings. I can data live log the air fuel using the logworks3 dashboard but the gauge just blinks 7.4. I'm at a loss... I can connect it to the LM programmer and configure the gauge but my gauge just blinks... The module and the O2 sensor are calibrated also! Ran threw the sequence and the light powers normally. Light on the module stays lit green and solid. Thanks in advance.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
RacinJason15
Expert
- Joined
- Jan 23, 2008
- Messages
- 253
- Reaction score
- 50
- Points
- 858
- Location
- Comstock Park, MI
- Country
- USA
- Snowmobile
- 17' Yamaha Sidewinder LTX DX
- LOCATION
- Comstock Park
Sent from my iPhone using Tapatalk
Not sure but the guys at Innovate will know right away. Very helpful. Give them a call tomorrow. Cool looking gauge!
You get it working?
RacinJason15
Expert
- Joined
- Jan 23, 2008
- Messages
- 253
- Reaction score
- 50
- Points
- 858
- Location
- Comstock Park, MI
- Country
- USA
- Snowmobile
- 17' Yamaha Sidewinder LTX DX
- LOCATION
- Comstock Park
I got it to read and stop blinking. However it doesn't read accurately. And is all over the place. Doesn't read a consistent. I can data log with my computer and it shows live readings and the gauge shows 22.4 and 7.4 and 11.4 intermittent.. I don't quite understand it.
I dialed the boost in at 5.5 lbs and it flat out pulls your arms off! It's very very impressive! Couldn't be happier.... Well a foot of fresh and I would be on cloud nine... Until next year![emoji51]
