Mooseman
I'm not all knowing. Post your question in forum.
- Joined
- Nov 3, 2009
- Messages
- 4,020
- Reaction score
- 1,036
- Points
- 1,733
- Location
- Greely, Ontario
- Country
- Canada
- Snowmobile
- '07 Venture MP (gone)
'07 Phazer FX (gone)
'09 Phazer GT (gone)
'10 RS Venture GT (My current ride)
'10 Nytro FX (son's)
- LOCATION
- Greely, ON Canada
I was just surfing around when I found these:
http://peterborough.kijiji.ca/c-car...4-stroke-exhaust-donut-set-W0QQAdIdZ216109488
Does anybody have any thoughts or experience with these types of donuts? Some posts I read say that too hard a material would crack the pipes but these are made of a "copper alloy", copper being a fairly soft metal. I know that the graphite stuff used on the OEM's just eventually burn off. I had the same problem with my older Blazer. All that would be left is the mesh and I remember wishing then that there would be a brass or copper replacement so I didn't have to replace them every year.
Thoughts???
http://peterborough.kijiji.ca/c-car...4-stroke-exhaust-donut-set-W0QQAdIdZ216109488
Does anybody have any thoughts or experience with these types of donuts? Some posts I read say that too hard a material would crack the pipes but these are made of a "copper alloy", copper being a fairly soft metal. I know that the graphite stuff used on the OEM's just eventually burn off. I had the same problem with my older Blazer. All that would be left is the mesh and I remember wishing then that there would be a brass or copper replacement so I didn't have to replace them every year.
Thoughts???
thrasher
TY 4 Stroke Junkie
- Joined
- Nov 22, 2006
- Messages
- 708
- Reaction score
- 63
- Points
- 928
- Location
- Ottawa Valley, Ontario
- Country
- Canada
- Snowmobile
- 06 Vector RS ER
Have no experience with that donut, but sounds good to me. Doubtful that it would harm the stainless steel pipes. Pricey compared to the gaskets in the US, but if you never have to replace them again and remove the pain in the #*$&@ factor when doing so, nice!
Makes me wonder why Yamaha doesnt go this route???
