nytrolabrador
Extreme
2011 xtx red light stays on at warm up wont shut off I I shut down motor it wont start again trnsover but no go.. if I wait half hour she will start but still red light stays on araid to run her...any help
?
?
are there any symbols on the gauge showing...any codes? Have you checked your oil level?
nytrolabrador
Extreme
no symbols oil is full and new...shaddow44 said:
Beenba
TY 4 Stroke Junkie
The red light is on for water temp. It goes on when u first start the sled up and goes out once the engine is warmed up. It will also come back on once the sled starts to overheat. I think we all know that, but just in case i said it.
Maybe your water temp sensor is disconnected? And the ECU cant tell if the engine is warmed up?? This would explain why it is staying on. I would put my money on that.
Maybe your water temp sensor is disconnected? And the ECU cant tell if the engine is warmed up?? This would explain why it is staying on. I would put my money on that.
Lee Rivers
Extreme
If your coolant level is low you may have an air pocket in the cooling system causing the sensor to not read properly. I'm not sure of the procedure to get a air pocket out but I think there is plug on the block to do that. It shows it in the owners manual somewhere (I think).
fxnytro1050
Expert
The cold weather is getting the best of her. Coolant heater and everything ordered for mine now lol
nytrolabrador
Extreme
fxnytro1050 said:
she has heater and is always plugged in...and why would u order the heater always in stock at hewlett
fxnytro1050
Expert
Really? didnt know that. Im home in NL and was browsing the yamaha site and seen it so ordered it throughthem. Pick it up tomorrow now.
