Nytro xtx to cat 153 skid swap

[philip]

Putting a 153 track on my nytro and a 153 cat skid. Looking for a measurement of where to drill new hole from stock hole. Read through few forms and can't find or maybe just missed a measurement for the xtx to 153.
Any help is great thanks

Sent from my SM-G920W8 using Tapatalk

 

[kennyspec]

http://www.ty4stroke.com/threads/the-arcitc-cat-float-suspension-thread.109029/

Have you looked at that thread? Lots of info in there.

 

[philip]

Ya i read it through. Can't find exact for the xtx

Sent from my SM-G920W8 using Tapatalk

 

[whitewheels]

You should have some "blind" holes on the side of the tunnle. That marks where rtx and mtx have their holes.....or maybe I remembred wrong. Dono if it differ from oem 153 skid to ac 153 skid but there i some mesurments in the begining of my build thred.....

 

[whitewheels]

http://www.ty4stroke.com/threads/building-a-mountainsled-of-a-rtx.119718/

 

[philip]

Ya there aren't any blind one. Had a fellow members here help me out just needed measurement from his drive shaft back. It's all together now and finally go to ride with my new turbo yesterday

Sent from my SM-G920W8 using Tapatalk

 

[philip]

Sent from my SM-G920W8 using Tapatalk

 

[philip]

Last pic the sled is lifted with strap

Sent from my SM-G920W8 using Tapatalk

 

[..SNAKEBIT..]

so how it working?
installed mine, but lack of snow for much ride time, ski pressure seems HIGH
I think I should lower frt bolt hole? frt straps all the way out and tight setting on cement

 

[philip]

Suppose to have about 1/2 inch of compression on front shock. Mine works pretty good. Just waiting on my buddy to plasma out my new tunnel extension and get it bent. Will pull skid and drivers out next week again when my 153 x2.25 track comes

Sent from my SM-G920W8 using Tapatalk

 

[..SNAKEBIT..]

Suppose to have about 1/2 inch of compression on front shock.

THATS what I was thinking couldnt figure why everyone was mounting the frt so high in the tunnel.
going to have to redrill & mount mine

 

[philip]

It's suppose to be 8 inches from top of tunnel to center of bolt

Sent from my SM-G920W8 using Tapatalk

 

[philip]

I'm throwing in a 153 x 2.5 attack 20 track . Anyone know if it will fit with 8 tooth 3 pitch wahl.? Or do I have to go to 7 tooth? Thinking then might have to drop to 19t top gear

Sent from my SM-G920W8 using Tapatalk

 

[kennyspec]

I have a 2.5 with stock mtx 7 tooth drivers and the track is real close to the bulkhead cooler. I don't think 8tooth would work.

 

[philip]

Ok good to know ya I think I'll just cut down to 2 inch for the snow conditions this year it will be good enough.

Sent from my SM-G920W8 using Tapatalk