Push button start?

[yukon yamaha]

Has any one put a push button start on their machine in place of the key?? If. So what did you use and were did you get the parts
Thanks!

 

[Dimebag]

Yeap. I got it.

I got the parts from a internet electronics shop. Nothing special about the parts, except you should get switches that can handle snow and moisture without freezing up.

One on/off switch for the ignition, and a push button switch for start.

 

[yukon yamaha]

How hard was it to wire in? And could I get a pict or two put up please

 

[Dimebag]

You cut into the four wires going to the ignition switch. The thickest ones for ignition, the thinnest for start. 5 minute job.

I can take a couple pics of my setup tomorrow if you want.

 

[yukon yamaha]

If you could hat would be great!
Thanks again

 

[Dimebag]

I couldn't sleep, so i went out in the garage to take some pics for you.
The ignition switch is the same diameter as the oem switch, so it fits in the oem location.

 

[yukon yamaha]

Thanks!

 

[Nikolai]

I've had it since '09. I hate keys.

 

[mtuyamaha]

Are you using a normally open momentary switch?

 

[HighSpeedLowDrag]

This is a kill switch with a momentary start button from a Yamaha sportbike. Its made to be out in the weather and the electrical pins slide right into the connector blocks.