2stroken
Expert
So does an MTX take longer to take the suspension out? I find that I have to take the tension off or the torsion springs to get the bolts out. Also I am upgrading my w arm and having problems getting the Allen bolt set screws out. Any suggestions, I twisted an Allen wrench clear off. Soaking them in pb blaster now.
Attachments
Mooseman
I'm not all knowing. Post your question in forum.
- Joined
- Nov 3, 2009
- Messages
- 4,115
- Reaction score
- 1,084
- Points
- 1,733
- Location
- Greely, Ontario
- Country
- Canada
- Snowmobile
- '07 Venture MP (gone)
'07 Phazer FX (gone)
'09 Phazer GT (gone)
'10 RS Venture GT (My current ride)
'10 Nytro FX (son's)
- LOCATION
- Greely, ON Canada
Those can get seized up pretty bad. I once had to bang one off using a hammer, marring the shaft, then cleaning it up and grinding down the set screw from inside. I then drilled and tapped another hole and used stainless screws. Anti-seize is also your friend.
2stroken
Expert
I am thinking of putting a little heat to the aluminum.
