reset falt codes

[srxtim26076]

I had a fault code flashing last season for the oil pressure. I replaced the pressure sensor and the code continues to flash. Is there a reset or should the code go away after the problem is fixed?

 

[natedawgedog]

are you sure its just the sensor and not your pump?

 

[rlcofmn]

The code will stay in your computer until it is deleted but it should go off the display next time you start it with the problem fixed. I would be very concerned without getting a actual oil pressure reading. Could be a damaged wire? Do you have a copy of the service manual?

 

[srxtim26076]

Thanks. The entire story is that my sled sunk last year. I changed the oil about 15 times and the fault code came up for oil pressure. The sensor was filled with ice when I removed it

There seems to be tons of oil pumping out of the hose and I drove the sled for a couple hundred miles.

But the fault code continues to flash

 

[SSX600]

ECU get water in it?

 

[srxtim26076]

what is the ECU ? where is it?