srxtim26076
Extreme
- Joined
- Dec 12, 2007
- Messages
- 66
I had a fault code flashing last season for the oil pressure. I replaced the pressure sensor and the code continues to flash. Is there a reset or should the code go away after the problem is fixed?
natedawgedog
TY 4 Stroke Guru
are you sure its just the sensor and not your pump?
The code will stay in your computer until it is deleted but it should go off the display next time you start it with the problem fixed. I would be very concerned without getting a actual oil pressure reading. Could be a damaged wire? Do you have a copy of the service manual?
srxtim26076
Extreme
- Joined
- Dec 12, 2007
- Messages
- 66
Thanks. The entire story is that my sled sunk last year. I changed the oil about 15 times and the fault code came up for oil pressure. The sensor was filled with ice when I removed it
There seems to be tons of oil pumping out of the hose and I drove the sled for a couple hundred miles.
But the fault code continues to flash
There seems to be tons of oil pumping out of the hose and I drove the sled for a couple hundred miles.
But the fault code continues to flash
SSX600
Lifetime Member
- Joined
- Feb 13, 2010
- Messages
- 430
- Location
- Richland Center WI
- Country
- USA
- Snowmobile
- 2010 Nytro XTX, 1997 Mtn Max 600, 1998 SSX600, 1975 SM292F, 1987 Inviter
ECU get water in it?
srxtim26076
Extreme
- Joined
- Dec 12, 2007
- Messages
- 66
what is the ECU ? where is it?
Similar threads
- Replies
- 9
- Views
- 2K
- Replies
- 2
- Views
- 610