mnman309
Expert
I am looking for any insight on running a single ply Cobra track.
jewill4
Extreme
A friend of mine I ran into last year was. 1 3/8 Cobra single ply. He loved it even though he was worried about the single ply issue. Him or his friend who had about 2k on the same trackloved it. Agressive riders too. Said it was holding up fine. Looked sweet on his sled too. It was a heavily moded XC 800 with 150 + hp.
I wouldn't run one personally, especially if you are going to stud. My cousin ran one with studs and it was constantly stretching causing him to adjust track tension.
LSXM3
Expert
I have one of those on my GF's Rev XP Ski-Doo and its been great since we put it on 700 miles ago, very light weight and didn't affect her top end going from a 3/4" to the 1 3/8".
jewill4
Extreme
Leeko makes a point. Probably not a good choice if your going to stud. I imagine pull throughs would be prevelant. Nytro's already have a racheting problem so if you change to this track, change your drivers so if the track stretchs your track tension isn't as important with our torque monsters. Other then that I think its a good economical choice. I wish our sleds came with 1 3/8 or 1.5 tracks. I might go to a 1.75 personally.
Similar threads
