Tool for changing belt?

[170plus]

lock brake and push the cam in with the palm of your right hand and push the belt down into the top of the secondary at the same time,roll it out the bottom,piece of cake on apex but a little harder to get a straight push on the rx models but still very easy once you get the knack

 

[rxrider]

lock brake and push the cam in with the palm of your right hand and push the belt down into the top of the secondary at the same time,roll it out the bottom,piece of cake on apex but a little harder to get a straight push on the rx models but still very easy once you get the knack

On the RX-1, RS series, unhook the side panel off the top right. Now you've got more room when wrestling with the secondary, then follow what 170plus says.

 

[SledFreak]

Here's a pic of the one I got from Rich installed.

I have one like that from TEAM and the bolt that touches the helix, made some good marks in it. Is that normal?

 

[1CrazySledder]

Here's a pic of the one I got from Rich installed.

I have one like that from TEAM and the bolt that touches the helix, made some good marks in it. Is that normal?

Yeah, it only makes one little mark where the L-bolt touches the helix. I put one on Vector for the girlfriend. Now even she can change her own belt when I'm not around.

Just if you take the secondary off for any reason, try to line the tool back up or you'll have more than one mark.

 

[Jigger]

Hey Rich received the tek-vest and clutch tool. Thanks.