Track ?

[Jim04RX1]

Studying and looking into the 121-136 mod. My question is. Is there enough room to jump up to a 1.50 from a 1,25 lug to clear heat exchanger?

 

[smokingcrater]

1.5 will just barely fit, depends on the individual track. Worst case you might have to trim a little where it touches the protectors.

 

[Jim04RX1]

So pretty much I'd be better off changing the drivers to accomplish this or stick with the 1.25

 

[stomper]

I have a 1.75 back country on my 03 with stock drivers.

 

[smokingcrater]

You must have trimmed it or dropped the suspension? My 1.5 rubs very slightly as-is, although there is clearance around the drivers, a 1.75 would fit there at least.

 

[stomper]

Nope. Suspension was in the stock position with stock drivers. When I install my zx2 I had to remove the tunnel protectors but before that it was all stock

 

[Jim04RX1]

Thanks for the info. I will be sticking with the Ripsaw or going with a Ripsaw II

 

[Jim04RX1]

One thing I just thought of. What kind of clutch adjustments will I need to make? Will primary be ok and make adjustment in secondary?