I want to install a ZEX tps switch to a Holtzman NO2 kit. Where does the switch fit in to the existing install?

87gtNOS
VIP Member
- Joined
- Nov 30, 2005
- Messages
- 1,892
- Reaction score
- 74
- Points
- 1,108
- Location
- Toronto
- Country
- Canada
- Snowmobile
- 12 Apex XTX MCX powered
Search my post on the Holtzman, I use the ZEX switch.

87gtNOS
VIP Member
- Joined
- Nov 30, 2005
- Messages
- 1,892
- Reaction score
- 74
- Points
- 1,108
- Location
- Toronto
- Country
- Canada
- Snowmobile
- 12 Apex XTX MCX powered
87gtNOS said:Search my post on the Holtzman, I use the ZEX switch.
oh and I see you have a nytro...the TPS wires are likely basically the same....
Your post is what got me to this point but I don't see any post that actually points out the location of the TPS wire. I think I have figured it out though its just in a spot that will require me to remove the fuel tank to make it easier to access. What did you use to splice the TPS wire? Scotch block?

87gtNOS
VIP Member
- Joined
- Nov 30, 2005
- Messages
- 1,892
- Reaction score
- 74
- Points
- 1,108
- Location
- Toronto
- Country
- Canada
- Snowmobile
- 12 Apex XTX MCX powered
nytrozula said:Your post is what got me to this point but I don't see any post that actually points out the location of the TPS wire. I think I have figured it out though its just in a spot that will require me to remove the fuel tank to make it easier to access. What did you use to splice the TPS wire? Scotch block?
I believe I actually snipped and soldered mine...
Similar threads
- Replies
- 16
- Views
- 2K