Search results

if i could offer any advice i would tell you get rid of the seat and suspension. i put an apex seat on... sits much higher and gets your feet underneath you. i also added an m 10 suspension. both are do it yourself projects and completely change the sled for the better. you also may want to add...

can anyone recommend a new temp gauge for my rx1... the one on there now reads about 30 degrees too hot.

i did the same thing last year. rather than doing bulkhead i jb welded holes. can also have a pro welder do it with an aluminum mig welder

i cast a vote for impact gun

few common upgrades to he rx1 are upgraded suspension(m10 and sc3) are common. and replace seat with an apex seat. much taller and easier to stand then the lower rx1. might also want to consider a 13 mm sway bar. sled has alot of body roll. bigger bar will address this

the clutch noise is nomal. it goes way with a few more rpm's

back in august i had ordered and payed for a new boss seat for my rx1.. couple of weeks ago i emailed to see when delivery would be made. they told me that they decied not to manufacture rx1 and apex seats this year. i was then given a refund after i asked them if they had any retailers that...

back in august i had ordered and payed for a new boss seat for my rx1.. couple of weeks ago i emailed to see when delivery would be made. they told me that they decied not to manufacture rx1 and apex seats this year. i was then given a refund after i asked them if they had any retailers that...

back in august i had ordered and payed for a new boss seat for my rx1.. couple of weeks ago i emailed to see when delivery would be made. hey told me that they decied not to manufacture rx1 and apex seats this year. i was then given a refund after i asked them if they had any retailers that...

i also have an 06 mxz with the sc4 skid... much beter than the sc3. if you have the opportunity go with the sc4 . much beter ride

how much height is gained by replacing a 03 rx1 seat wih a apex

how much does the conversion and mount kit?

correction... it is a fast m10 not polaris. does that make a difference in the shafts and attatchments?

what mods are needed to put an m 10 from a polaris in an rx1?

what mods are needed to put a m10 skid from a polaris in an 03 rx1

you can get a boss seat for 400 delivered from first place parts

might want to consider a boss seat. i just ordered one for around $400 . can't wait for it to show up

store it in maine... real cold not moist

there is the one main tube that comes down from the middle of the sled and then runs to the toop of the carbs, where it braches into two smaller lines that goes to the left and right of the carbs. the main one actually an see h2o shooting down. i can disconnect it and pour a small amount of h2o out

i had traded a skidoo rev for an 03 rx1 last year. thing is very vast, but not very comfortable or easy to ride. i find it difficult to stand up on it. also not very good in the bumps. and alot of work is needed to corner. i have a boss seat on order and have put 3 inch bar risers on. What else...