vector

Trying to deal with a broken stop/kill switch button on a 2009/10 Vector. I say 2009/10 because this is technically a 2009 model but has the 2010 fuel injected engine (I guess it was an early release or something). Looking at the parts list for these 2 years the stop switch (red button -...

Hey guys. So tonight I was taking my carbs apart for a cleaning, and took these out. Which I believe are the pilot screws? Anyways I took all the jets out, floats off, the pilot screws out, and am going about blowing out my carbs. Then all of a sudden there where parts flying up into my face...

Hey guys so here is what I have done so far. Charged the battery up to peak, I installed the new Bulkhead saver kit, Hid lights, 13MM sway bar, with new bushings, took the seal off of the jackshaft bearing, and drive bearing, and repacked them with new grease, took the clutches off (on the bench...

Greetings! I have a "general" question, as a member of this forum , does any of the Ski Manf. offer discounts to Yamaha Snowmobile owners? This year I am working on a Project to extend my 2005 Vectors Track to 144 and upgrade to more of a CrossOver Ski for flotation, so I am wondering if any...

Just wondering what you all are doing/have done to your Yamaha vectors this summer. I still need to take my whole rear suspension out, grease every thing up, clean the clutches, install a new fuel pump, change the motor oil, new slides (DuPont). And the only mod/ necessary part I am going to get...

Just finished installing a Camso Ice Attak XT (pre studded), 1.2 lug on a 2013 Vector LTX. The skid isn't installed yet, so the track is sitting on the drive sprockets only by weight, but I find the the web between the lugs, in line with the clips rubs against the front tunnel tubing, about 2mm...

My 2012 Vector now has over 8000 miles on it. Noticed after the last trip that most track clips are compromised or missing. So I can buy clips for about $130.00 and hopefully borrow the tool to rebuild the track that might have 2000-4000 miles of life left, or replace the track for more like...

Ok.. so I shimmed the front skis. Yes, darting was tamed down by doing this, but it still holds similar difficulty in turning and fatigue is there. Burned me out. Need some basic help in further setup

Hello everyone, I just bought a 2010 rs Vector l-tx gt, and I'd just like any advice I can get in terms of if anyone know what any problems are with the sled, I need to know if there is anything I should look for or change in case this model has any problems, I know that the primary clutch is...

I have a friend of mine that just purchased a 2008 Vector and is looking for an aftermarket exhaust. Is there such an animal? He's wanting a little more rumble. Thanks Shane

Whats the best clutch to put on this sled?

looking for some suggestions. The primary needs replaced due to the grooves in the sheaves. Would I be better off replacing the whole primary with a Team or Comet....or would just purchasing a low mile used YXVC clutch and rebuilding it be the way to go? If I go the rebuilt route, can anyone...