Kmilley
Newbie
- Joined
- Mar 3, 2019
- Messages
- 2
- Reaction score
- 0
- Points
- 91
- Location
- Ottawa
- Country
- Canada
- Snowmobile
- Yamaha RX-1 ER
Yamaha Venture 500 XL
Hey guys, I'm fairly new here but I'm just looking for some potential guidance in regards to a little oil I found underneath my snowmobile. I recently changed the oil as well as the oil filter and I'm wondering if maybe I didn't tighten something fully or if I accidentally pinched or hit a line when replacing all the parts.
So far I have stripped the airbox off and the felt around the oil filter and didn't feel any oil or leaks coming from there. I also took the skid plate off and it seems to be dripping out from the middle of the underbelly of the sled. I do remember spilling a little oil when I was replacing the oil, but not nearly the amount that I see.
The sled doesn't leak oil when it is sitting, only when it is started warmed up and then shut off... I will attach pictures to show what I see that is happening.
Thanks in advance.
Sled has 30k but is in super nice shape all around.
So far I have stripped the airbox off and the felt around the oil filter and didn't feel any oil or leaks coming from there. I also took the skid plate off and it seems to be dripping out from the middle of the underbelly of the sled. I do remember spilling a little oil when I was replacing the oil, but not nearly the amount that I see.
The sled doesn't leak oil when it is sitting, only when it is started warmed up and then shut off... I will attach pictures to show what I see that is happening.
Thanks in advance.
Sled has 30k but is in super nice shape all around.


- Joined
- Jun 1, 2004
- Messages
- 7,833
- Reaction score
- 2,033
- Points
- 2,103
- Location
- sudbury on
- Country
- Canada
- Snowmobile
- 2016 apex xtx
2011 apex xtx
2009 phaser rtx/x
1997 et410t/r
1988 vk 540
do you still have the old oil filter? check and see if it still has its o-ring. seen it happen a few times where it sticks to the block.

biffdotorg
VIP Member
- Joined
- Dec 2, 2008
- Messages
- 2,211
- Reaction score
- 1,126
- Points
- 1,583
- Location
- Pelican Rapids, MN
- Website
- www.biff.org
- Country
- USA
- Snowmobile
- Apex XTX and Viper LTX SE
- WEBSITE
- www.biff.org
I agree with the O ring as a possibility. Also, did you do your change with the kit? there is a washer than can be replaced on the drain plug. I would have to say that I don't replace that washer all the time, but there is a reason a new on is in the kit.
Good luck.
Good luck.
Kmilley
Newbie
- Joined
- Mar 3, 2019
- Messages
- 2
- Reaction score
- 0
- Points
- 91
- Location
- Ottawa
- Country
- Canada
- Snowmobile
- Yamaha RX-1 ER
Yamaha Venture 500 XL
Thanks for the replies, I only changed the oil filter with the one that I purchased off some website ( can't remember now, but I believe it was DennisKirk ). When I took the old oil filter off I compared the two filters and they were exactly the same, I check the O ring as well to ensure it was the same and it was. I didn't get any kit, but there is no oil dripping from around the drain plug at all.
Im going to have a look at it this week sometime and see if I can find anymore signs of a leak.
Thanks again.
Im going to have a look at it this week sometime and see if I can find anymore signs of a leak.
Thanks again.
Fortress
Pro
- Joined
- Dec 18, 2016
- Messages
- 169
- Reaction score
- 28
- Points
- 463
- Location
- West Canada
- Country
- Canada
- Snowmobile
- 2004 RX1
You can jack it up run it with skid plates off, I had several leaks on mine but they all fixed now.
Similar threads
- Replies
- 0
- Views
- 448