Display gauge

[CooperT]

I figured I would post it here because it can apply to the winder or viper. I have an irritating line going through the left side of the screen on my viper, basically cuts off half of my temperature readout. My question is, if I bought a new display gauge would the dealer or anyone be able to pre-program the kilometres on to the new gauge? I’ll get a picture tomorrow morning...

 

[G.I. Joe]

I believe that is saved in the cpu. No programming necessary

 

[CooperT]

I believe that is saved in the cpu. No programming necessary

so everything should come back? Hrs? Trip? ODO?

 

[Confused]

Odometer and hours should. Trip probably won't

 

[Srxspec]

Mileage I believe is stored in the gauge cluster, hours are stored in the ECU. So if you buy a new gauge, it will show 0 mileage, but will show the correct amount of hours.

 

[CooperT]

Mileage I believe is stored in the gauge cluster, hours are stored in the ECU. So if you buy a new gauge, it will show 0 mileage, but will show the correct amount of hours.

This is what I was afraid of hearing, do you know if they could possibly be programmed?

 

[Srxspec]

There is not a way to program it that I'm aware of.

 

[CooperT]

There is not a way to program it that I'm aware of.

Ok thank you!

 

[STAIN]

SRXspec is correct. I had a gauge warrantied at 5300 miles. The new one read 0 when I picked it up. The hour display is correct.
I took a picture of the mileage before the exchange so I could relay this to the next owner.