thetruck454
TY 4 Stroke Junkie
I pulled the heat shield off under the gas tank to try to get at the last rivets for the tunnel protectors. Failed attempt, but what I did notice was that thermal cloth is all falling apart and right above where each exhaust tube is, it was gone. So that heat shield would be more like a heat conductor with the bare aluminum showing in some spots. Any one else notice that?
Also since I had to drill the rivets out, I need to replace 16 of them. I had some 3/16" (4.7mm) and they looked to be a bit too small. I'm assuming they are metric and the next biggest size is 5mm?
Also since I had to drill the rivets out, I need to replace 16 of them. I had some 3/16" (4.7mm) and they looked to be a bit too small. I'm assuming they are metric and the next biggest size is 5mm?
arteeex
TY 4 Stroke Master
Check your exhaust gaskets too. If they're leaking, as mine were, it will burn out the insulation - right above the flex joints. I used some heat shield material from Moose Racing to patch my system.
You can get rivets thru McMaster.com. Look at the high-strength steel units.
You can get rivets thru McMaster.com. Look at the high-strength steel units.
thetruck454
TY 4 Stroke Junkie
Is there another way besides running the sled with the fuel tank set off to the side. I still am under warranty till mid December so maybe I'll just bring it in to them... I do have header wrap left over from my truck exhaust, maybe I'll use that.
