HammerTime Update #2 question

[Hotfingers]

So in the mail 2 weeks ago I get the pin update for the weights. I installed them, and I thought I was ready to go. Now today I got 3 NEW weights in the mail. The instructions include the same instructions on replacing the pins. Now the question: Do I replace the pins in the new weights also?

The instruction have in bold print "Do not use the 40-20 weight combination in the RX-1" The new recommenation for the weight setting is 4.2/3.0/0.0 (shoulder/center/tip) and white spring.

I had the sled all ready to go, in the trailer, to go to the U.P. this weekend for a week,now I got to do this update. Oh well.

-Hotfingers

 

[wizard]

I got the new set of weights as well, already assembled. They are 50-10 with the aluminum hammer. They already had the new rivit crimped down. They must have retested his theories, but I guess the old weights are no good.

 

[Srxspec]

Run the new weights with the pin that came in them. The new weights are made out of billet after quality problems with the old weight material. Also run the new recommended setup.