Hygear linkage kit setup help

[DelgatyXTX]

I did some searching on here but it seems like everyone has the additional pressure chamber whereas I didn't. I set the float to 130 psi where I've read it' supposed to be for the stock setup and the rear end sags so bad the flap almost touches the ground. I was finished working on it for the night so I didn't try anything and figured I'd maybe get some pointers on here before I look at it tomorrow. Any help is appreciated.

 

[Hurulau]

Just installed linkage to my xtx. Im about 180lbs with riding gear. I have fox float evol rear shock. ~180psi to main chamber and sag is about 2.75”. Installation manual says that right sag is 3”.

I think evol chamber dont affect sag at all. You set your sag with main chamber.

 

[jpothof]

I did some searching on here but it seems like everyone has the additional pressure chamber whereas I didn't. I set the float to 130 psi where I've read it' supposed to be for the stock setup and the rear end sags so bad the flap almost touches the ground. I was finished working on it for the night so I didn't try anything and figured I'd maybe get some pointers on here before I look at it tomorrow. Any help is appreciated.

I think you might have a leak in your shock. Fill it up to 130psi and put it in a bucket of water. Look for air bubbles. If no leak I’d keep increasing the pressure. I know it’s different with the dual pressure chamber but ride height is 200 psi with the dual pressure. Good idea to drop hygear a line and get their thoughts too.


Sent from my iPhone using Tapatalk