cw xtx 1.75
Veteran
- Joined
- Jun 12, 2014
- Messages
- 46
- Age
- 44
- Country
- USA
- Snowmobile
- 2013 Yamaha Nytro xtx 1.75
So i installed a LE 2.5 pivot riser , my throttle cable seems tight but when running on the stand and turning the bars side to side the throttle stays the same and does not jump . My ? is have others had to re route there cable ? Put a MTX cable on ? My sled is a 2013 xtx . Also if i were to put a relocate on of some sort would i need a new cable then ? Could i keep my 2.5 and add a relocate ?
- Joined
- Apr 13, 2003
- Messages
- 21,493
- Age
- 54
- Location
- Schofield, WI
- Website
- www.totallyamaha.com
- Country
- USA
- Snowmobile
- 2020 Sidewinder SRX
Can you route the cable under instead of over to the throttle block?
I have a lake effects 2.5 riser and the oft relocater on a 09. Throttle cable is routed on the back side of the bars. I have had no throttle related issues.
bmazbnytro
Extreme
Ditto, I have a ROX 3" pivot riser and relocate with no trouble. Did relocate cable though but I don't remember where. I just moved it around until it worked the best. I did have to lengthen the adjustment on the cable.
Similar threads
