Launch Control, Stutter Box, 2 Step

[SRXNOMO]

Has anyone been able to make the msd 4350 work on an RX1? I have one and was hoping to use it this summer. If not what works. I need to build boost for launching my rear mount rx1. What about header/exhaust design???? Our guy that builds headers and inner cooler piping is offering to make me a header cheap, but will it make a difference>>> ?????<<<

 

[tapex_07]

It will not work on an RX-1. Has to do the cdi ignition. I believe you have to get the whole MSD ignition setup for the 2-step.

 

[SRXNOMO]

Yeah, that's what I was afraid of. I had read an old message from the guy at msd saying it might, then i found another old post saying that it wont because of the cdi. I was hoping someone figured out a way since then. If anybody know what parts I need to make hook it up that would be cool. I am not afraid to spend a some money to get it going. Tapex, thanks for the reply.

 

[tapex_07]

No prob, I would contact Dave at Hurricane and see what he has to offer for advice. Hes a site sponsor here.

 

[TurboTime]

No prob, I would contact Dave at Hurricane and see what he has to offer for advice. Hes a site sponsor here.

And or Jim at OSP, between those two they should be able to figure something out for you..

 

[yukon yamaha]

what do you mean when you you say two step??

 

[SRXNOMO]

It's an electronic device that works with your ignition and allows you to launch at a certain rpm, or in this case a certain boost.

 

[SRXNOMO]

http://www.youtube.com/watch?v=M8SkRCHgqBA