sofunkingcool
Extreme
Hey, I was just wondering on how they are holding up for everyone? Are they any better than stock? I have to do something with mine this year I have a new set of ball joints but wondering if i should just wait and get NCI replacements. Thanks any info is cool
Mooseman
I'm not all knowing. Post your question in forum.
- Joined
- Nov 3, 2009
- Messages
- 4,020
- Reaction score
- 1,037
- Points
- 1,733
- Location
- Greely, Ontario
- Country
- Canada
- Snowmobile
- '07 Venture MP (gone)
'07 Phazer FX (gone)
'09 Phazer GT (gone)
'10 RS Venture GT (My current ride)
'10 Nytro FX (son's)
- LOCATION
- Greely, ON Canada
Two seasons and about 2500 Km, still solid. I have to admit that I added grease zerks to the spindles so maybe I'm getting better service out of them but the description says that they should last up to 4000 miles as-is so YMMV.
Spindle/Balljoint mod for zerks
Spindle/Balljoint mod for zerks
May just be me but mine wore faster than stockers.Ran out of shimming ability in two seasons.Maybe I got a bad set but I contacted them with no help offered so will be going back to stock.
Nine2Nine
Expert
cannondale27 said:
.005" Shim after the first year and will do the same again this year, the guys supplied some shims no problem.
PoliticalMachine
Pro
- Joined
- Oct 20, 2010
- Messages
- 155
- Reaction score
- 0
- Points
- 716
- Location
- Valparaiso, IN
- Country
- USA
- Snowmobile
- Yamaha
cannondale27 said:
X2 on the nci ball joints. Mine lasted a season. For my fix I bought the skinz front end.
sofunkingcool
Extreme
Thanks for the replies, I like the zerk idea maybe I will try and do something like that with my stock ones. The replacements seem a bit exp. Thanks
Mooseman
I'm not all knowing. Post your question in forum.
- Joined
- Nov 3, 2009
- Messages
- 4,020
- Reaction score
- 1,037
- Points
- 1,733
- Location
- Greely, Ontario
- Country
- Canada
- Snowmobile
- '07 Venture MP (gone)
'07 Phazer FX (gone)
'09 Phazer GT (gone)
'10 RS Venture GT (My current ride)
'10 Nytro FX (son's)
- LOCATION
- Greely, ON Canada
Just an update on the zerks. Not sure what the width of the Nytro's spindles is but if they're as narrow as the Phazer's, I'd put them either on the front or back of the A-arm instead of the side like in my pics. On my Venture MP, the spindles are wide and protect the zerks well but on the Phazer, they are exposed and can be ripped off. And instead of grinding the inserts, clamp them together and drill a proper hole. Makes it neater and will allow the zerk to go in more for better retention and preventing the bronze inserts from rotating.
BigShow29
Pro
Mine were shot at 400 miles.. Went back to stock..
