Header is cracked out bad and possible ice went through the turbo. Let me know what would be the best route. Header lasted two years, this is on an Apex Mountain, ride between 8-11 feet. Thanks
stock motor no shim running at 10 to 12 psi
There is a used one for sale in the classifieds, Or if you are looking for a new set up Kevin(need4speed) is making some nice ones, or powderites has replacements for CPRs.
Look and see whats bad on the turbo, you can get parts for them to repair. Either Ted Jennetty can hook you up or dave @ powderlites.
Look and see whats bad on the turbo, you can get parts for them to repair. Either Ted Jennetty can hook you up or dave @ powderlites.
What turbo do you have? I have a good center section for a 2554 that I can hook you up with.
Turbo not that bad still running. need more boost
STOK TURBO? WORKS GOOD TO 12PSI HANGS WITH STAGE TWO TIMBERLINE SUPER CHARGER PULLS HIM OM THE HILL.
Give dave @ powderlites a call and get the GT2860 he has, do cam timing and run his header and Divorced down pipe. That is bigger and better then what you have and will work for pump gas. Plus that turbo is good till about 16 lbs boost on race fuel
mulot30th
Lifetime Member
- Joined
- Jul 7, 2007
- Messages
- 1,634
- Age
- 49
- Website
- youtube.com
- Country
- Canada
- Snowmobile
- 2023 thundercat
apex mountain crracing 174
apex blower 136 for asphalt racing
osp drag race sled (apex engine based)
aja636 said:
2860 will go MUCH MUCH higher than 16 psi.
MulotTurbo said:
I was just suggesting that due to stock motor, no shim, or low compression pistons. Am I close? What would be the boost limit on stock motor on race fuel??
will a bigger turbo clear the plastic. more lag? I think I'm over working the smaller tubo at elevation.
Dave has a very special header built, coated, and ready to ship right now that is a 'CPR dimension'. It is built for me, but I'm a few weeks away from needing it. If you want it I'll call Dave and as long as he can twist me up another one in the next few weeks you're welcome to mine.
Jim, is this header something fancy that I should be looking into as well??
Thinking of replacing my header next season, was looking at kevins, After looking at his work it hard not to want one of those things.
aj
Thinking of replacing my header next season, was looking at kevins, After looking at his work it hard not to want one of those things.
aj
aja636 said:
I'm working with Dave to develop an apex kit that doesn't require the headlight delete/gauge relocation. This header is part of that kit, and yes, it's fancy.
How's your pop making out with getting all of his stuff to fit?
he ended up getting the hot mods xxx hood and using Piaa lights, No luck getting the stock stuff to fit, But it looks good, he likes it, Sled is running super nice, and FAST. he just went racing with it yesterday and loves it, Now needs more picks and some set up on suspension, it is hooking off the line so bad he can't race if anyone is on his right side, he will hit them off the line.
I haven't put my sled against him yet, I am letting him get warmed up to me smoking him!!!
I haven't put my sled against him yet, I am letting him get warmed up to me smoking him!!!
