number1kyster
TY 4 Stroke God
Well i decide to change my gear today on my vecotor er. Everything went well until I got it back together. I put it in reverse but then it would go into forward after that. I took it apart again and really cant seem to figure out where i went wrong. Should the reverse linkage be flat against the inside of the cover when i put it back on or should it be in the up postion? Any tips would be helpful!
Len Todd
TY 4 Stroke God
Your are probably on the right componet. The linkage position is critical. The adjustment length is also critical. On my RX-1, the upper linkage rod sits below the shift arm and bolt is pointing up. On my sled, if you do not position it that way, you can't get the Brake back on.
BTW: Are you missing the word "not" in your post?
BTW: Are you missing the word "not" in your post?
- Joined
- Apr 17, 2003
- Messages
- 5,347
- Location
- Menno, SD
- Website
- www.ulmerracing.com
- Country
- USA
- Snowmobile
- 2014 Yamaha SR Viper LTX, 2014 Yamaha SR Viper RTX SE, 2015 Yamaha SR Viper MTX SE 162 (turbo), 2015 Yamaha SR Viper MTX SE 153
- LOCATION
- Menno, SD
- WEBSITE
- www.ulmerracing.com
The "arm" or "lever" inside the chaincase cover must drop down in the "slot" in the gear from the top side.
number1kyster
TY 4 Stroke God
Thanks ill try it!
4strokesmoke
Extreme
Haahah the saim thing happend to me today 
dam, now i have to take it all apart again
dam, now i have to take it all apart again
number1kyster
TY 4 Stroke God
I got it all fixed and the sled rocks! Cant wait to try it on snow!
Len Todd
TY 4 Stroke God
What was the problem?
powderpimp1
Expert
"I got it all fixed and the sled rocks! Cant wait to try it on snow!"
Good luck, Dont think we'll ever get snow.
Good luck, Dont think we'll ever get snow.
