please help identify a couple of extra parts .... and a connector pls

[xsivhp]

I have two bolts and a one pin connector I need help identifying. The connector has a yellow wire with a green stripe.

The wire is near the POS(+) battery post.

 

[ZapeX2]

I have my sled torn down right now so I'll go out and check in a hour or so. Have you been doing any work recently to give an idea where the bolt may be from. Steering block maybe... I'll check...

 

[xsivhp]

I replaced the a-arm bushings so I had the instrument pod, hood, air box and battery out, I also serviced the chain case.

Your help is much appreciated. I tool the sled apart about a month ago and just got to putting everything back together. My memory just isn't what it used to be ....

 

[ZapeX2]

I just went out and checked, the wire is for the coolant temp sensor(I think). sending unit is right beside the starter. The bolts got me a little baffled. They sure look like the bolts that hold the upper side steering block on. The one right by the reverse lever. I'm almost certain they have something to do with steering because of the hole for a pin. hope this helps a little. If ya need anything else, let me know, mines in pieces right now...

 

[xsivhp]

I just went out and checked, the wire is for the coolant temp sensor(I think). sending unit is right beside the starter. The bolts got me a little baffled. They sure look like the bolts that hold the upper side steering block on. The one right by the reverse lever. I'm almost certain they have something to do with steering because of the hole for a pin. hope this helps a little. If ya need anything else, let me know, mines in pieces right now...

I don't see either - could you please post a pic?

 

[ZapeX2]

Hope these work... I would check every steering component for missing bolts... If you had your A-Arms off maybe bolts from tie rods???

 

[xsivhp]

cool - ill take another look- thanks!

 

[xsivhp]

Well I got the wire plugged in - just need to figure out the two bolts.


I like snowbikes

 

[steiner]

Looks like the bolt for the tie rod end

 

[xsivhp]

I'll take a look at that, I had some used parts maybe it fell out of that box... I'll keep you posted.

 

[henseljg2]

Tie rod. Washer goes between ball joint and spindle steering tab.

 

[xsivhp]

yea I think you are right, must have been in my box o parts - thanks for the help guys! She's almost back together.

 

[ZapeX2]

Glad ya got it figured out....