POLL your skegs

[mbw919]

Woody's 6" Trailblazers on stock skis, shims, and no studs in the track.

 

[Flipper]

Studboy shaper bars for me. They are 8" or 9" I don't recall which.

 

[YAM182]

Curve skis and Stud Boy shaper bars.

 

[Riceburner]

Deuces .

 

[kyzer]

Have Dooly's but going to try Deuces.

 

[srxpotts]

sud boy 8" shapers

 

[maim]

i have run stock yammy bars, stud boy square rods, cb performance and the cheap ones sold at royal. all of them other than stock have been 6" carbide and the cb ones seem to be the best so far on the stock skis. i would reccoment the stud boy square ones to anyone with worn keels on their stock skis but beware as it makes for very hard steering. goes right where you point it though.

 

[kinger]

Woody's Dual'ies on our vector and zero darting but push in corners and scrub about 8mph off the top end.

 

[apltx08]

DEUCE on stock shimmed skis and work fine

 

[SRX Maine]

Stud-Boy shapers bars seem to be pretty popular here too.
I talk to Scott today and He thinks I should try out the Good & Ugly 6" T-III with ski$avars & 3/8 shims.
BTW, What a great guy to talk to on the phone.
Thanks for all the replies.

Bob

 

[BETHEVIPER]

for the stock ski, i like the arctic cat dually caribide, i was at the cat dealer today and he had a new kind of carbide that is aftermarket and can be used on any sled, they are a more agressive version of the cat offset duallys.

they use sqare host bars and carbide on both bars. leading edge is very tapered for better bridge and rail road crossings.

cant find the website

 

[sonic blue]

Shaper Bars

I ran Studboy 9" Shaper Bars on stock Yamaha skis last season and I shimmed under the ski rubber. This season I'm running Simmons skis with 4" carbides.

 

[06apexrtx]

Stud-Boy shapers bars seem to be pretty popular here too.
I talk to Scott today and He thinks I should try out the Good & Ugly 6" T-III with ski$avars & 3/8 shims.
BTW, What a great guy to talk to on the phone.
Thanks for all the replies.

Bob

ive been trying to get my set of his carbides since in oct. and he just put me off again for another week. so if i can find them today im going w/ stud boy deuce. i think its crazy to have to wait this long for them and a bad way of doing bussiness.

 

[Grimm]

Stud-Boy shapers bars seem to be pretty popular here too.
I talk to Scott today and He thinks I should try out the Good & Ugly 6" T-III with ski$avars & 3/8 shims.
BTW, What a great guy to talk to on the phone.
Thanks for all the replies.

Bob

When you get them in January, I'd like to hear your view of him then.

 

[studdog]

Berstrom 8 inch triplepoints with skisavers on Slydog Powderhounds, shimmed in front. 1/8 inch toed in. Running 09 Venture GT