grizzly101
Veteran
- Joined
- Jan 7, 2010
- Messages
- 35
- Reaction score
- 0
- Points
- 856
- Location
- saskatchewan
- Country
- Canada
- Snowmobile
- 2011 apex xtx, 2010 rs vector gt, 2002 sx viper,1998 venture 600
have a 2011 apex that i was working on skid had to take off torsion springs a nd now cant pull springs into place too much torsion for me anybody have any tips for pulling them back into place
- Joined
- Jun 1, 2004
- Messages
- 7,989
- Reaction score
- 2,110
- Points
- 2,103
- Location
- sudbury on
- Country
- Canada
- Snowmobile
- 2016 apex xtx
2011 apex xtx
2009 phaser rtx/x
1997 et410t/r
1988 vk 540
i usually only remove the long end as it is almost impossible to get enough leverage for short end.
make sure the spring tension adjuster is on the lowest setting. i then either muscle the long end into the holder by hand or if i am feeling lazy, i use a prying device/bar. i then use a wrench on the tension adjuster to set it where i want for ride.
make sure the spring tension adjuster is on the lowest setting. i then either muscle the long end into the holder by hand or if i am feeling lazy, i use a prying device/bar. i then use a wrench on the tension adjuster to set it where i want for ride.
