Recent content by Muffin

Yep

I ran about 6 pounds of boost. Nothing wild. Regular 91 non ethanol pump gas. 8 mpg is all you should expect. The blower is running all the time and it takes HP to make HP. I only had it one season. Ran fine other than it always ran HOT. I could never seam to keep temps down. I think it was...

I have some I drew up. PM me and I'll send them to you.

Haydays is always the weekend after Labor Day. So this year it is September 9th and 10th.

I'll be there. Selling Viper, Nytro and other Yamaha parts. I also will have trailer cabinets for sale again this year. Look for me and Mr Sled over near Ulmer Racing in the swap area.

The riding position on all the modern sleds favor an active rider and are comfy, for shorter riders. I agree with Mr Sled, tall guys suffer a little.

pressure is pressure. As long as whatever pressure gauge your using is accurate, go for it.

It comes out, Gotta remove all the guts and jackshaft, and all the bolts/nuts fromt he inside of the tunnel.

Does Textron build/own Ezgo golf carts? I see some advertising for Ezgo from Country Cat. Maybe Textron wants the dealer nextwork? Yamaha makes golf carts and golf cart motors as well. Food for thought.

X2 By far the most people where in the Ski Doo area (and they did'nt even have a trail sled there) then was Polaris and last was Yamaha. Not sure why. I think the looks of the new Doo's are horrid.

I've seen it done a couple different ways. One is with a heated knife that is specific for the job. The DIY guys just use a sawzall with either a fine blade or knife type blade. Then use two blocks or peice of pipe, in this case 2.5" tall/round and put one on each side of the paddle to use...

I always a jump pack to start the sled first thing in the morning, especially when its cold. It turns the motor over a lot quicker. After that cold morning start, things seam fine. Also, try dumping those crap Cat batteries and replace with a good aftermarket.

Tracks USA carries rail extensions. www.tracksusa.com

Tracks USA carries rail extension

The service manual has all the specs. I think it's available in one of the sticky's