Search results

I have 1983 Tri Moto 200EK (Shaft drive). It was a little hard to start and kicked back sometimes when starting with the recoil. I broke down and replaced the starter clutch so I could start it easier. It hasn't helped. Here is what is happening and hope someone has some ideas: 1. It tries...

I have 2400 miles on my 14 Viper and plan on changing the wobble bearing and bushing this year. I would prefer to install a final solution that prevents needing to do this so often. So which makes more sense to install? Order the 2017 Jackshaft and bearing (eliminating the Wobble Bearing) or...

Wanted to say thanks to Cannondale27. Revalued my skid shocks. Just spent a week in the UP riding and ltx se soaked up the bumps. Huge improvement. Maybe QS3’s for the front next year. Totally worth it.

Took it all apart for a rebuild and shock revalve and simply forgot the orientation of the pivot arm the rear most shock connects to. See pics. Rear of skid is to the right in both pics.

looking to get a lift that holds the entire sled in the air while I do off season maintenance. What works well with the vipers and doesn’t damage anything?

I am going to send in my rear shocks for a re-valve to Cannondale. However I am wondering if I should also put a dual rate spring on the front skid shock and the Cat softer torsion springs on at the same time? 2014 ltx SE with 1800 miles and I am 235 dressed out. Thanks. Want the best ride...

Recently I noticed Port Yamaha advertising very strongly for Arctic Cat. Bleeding green slogans etc. I take them to be a very well known and large mover of Yamaha sleds (I bought there). Could they know something we don’t about the future of Yamaha and are proactively taking steps to shift to...

i want to order the JT products tri-hub replacement and there are two options for wheel size. What is the stock siz3 for a 2014 Viper ltx se? Thanks

Live in Texas, get one week a year to ride in the UP. Trip was 3rd week of Feb on a new Viper. Basically everything I heard about this sled was true: The Good Handled great compared to my Apex LTX SE - too much rebound in rear skid but not too bad (shock re-valve needed - Hello Canondale)...

I have a new leftover LTX SE. I only get to sled fort one week a year as I live in Texas. Sleds stays at my place in the UP. So, my plan is to break it in the first 2-3 days then do an engine oil change. Do I need to do chain case at that time? I normally would want to do it but it is time...

Just saw this posted on Maters Stop-n-go’s Facebook page. Alger County in the UP. Apparently one dead and one in serious condition. “Hearing reports of the first snowmobile fatality of this season, very sad to hear this, how about we make sure this is the only one this season, please, please...

I have always studded my sleds but am going to leave this LTX stock. It is a 14 so has the Cat ski. Going with the double down carbides (like the slim Jim). So no studds and 137 track and trail riding. Is 4inch enough? 6" too much?

I have an almost new pre-studded 136 track on my Apex. Recently bought a left over LTX Viper. Think I could swap tracks?

I have a new (leftover) 14 ltx with zero miles I picked up in April and hauled back here to Texas so I could go over it before next season. It has been sitting in my garage the entire time. I just recently notice the rear suspension is completely collapsed just sitting there. I can lift it up...

yep. Parts of Newfoundland got that much between March 31st and April 4th. This is my father in-law from a day or so ago.

I have a new leftover 14 LTX SE with zero miles. I don't want to fully clutch until it is broken in because I want to set it once and leave it alone (Live in Texas, sled in UP for a week a year and no time waste adjusting during that week). Can I buy the midnight blue secondary spring, shim...

I can't check myself as I live in Texas and the sleds are in the UP. Was going to order carbides and need to know if I can pop the Dual Tuners on the Viper. Thanks

Knowing what you know about the Viper would you buy a leftover 14 ltx for $7500? I know there are a lot of issues I would need the dealer to take care of before pickup but I can't ride the old Attak any longer, even though it gave me 11,800 flawless miles and the motor still makes me moist...

I ordered a set of the first Gen tuner ski's for my Attak. I am looking to order a 4" 2" setup. Where are you order the runners from? It seems the sites I have looked at (Stud boy, Woody's) list them for 2015 and up. WIll these fit all Tuners?

Hi, Just ordered a new track. Ice Attak XT in a 15* 136, 1.22, 2.52 pitch and fully clipped. I am also changing the drive shaft and want to add anti ratchet drivers. Questions so I can order them. How many tooth? 8 or 9? What came on it? My sled is in Ohio in storage and I am in...