Search results

Ouch! Guess I have some work to do

Every turbo owner must have experienced execive heat.I had to mount an extra cooler on the rear,even after that it totaly emptied the expantiontank for antifreeze and I run a shorty in the flatlands!At first I thought it was a bad leaking but when I put the hose from the antifreezetank ta a...

Re: Ken-Climb log in.

How did it go with the measurment?Coolant out through the overflow or headgasket?Same problem here.

I have two yam.gaskets and 10:1 pistons,works allright with our 98 oct. But I´ve been running on the edge of meltdown since I got the motor to run perfectly yesterday.It launched like a dragsled and pulled harder and harder,felt like 3-4 sec to 100 mph. Boostmeter has never showed more than...

Thanks Parker,I will leave the wrenching until next season,done enough so far.

I guess I have to buy new ones... does this have any effect on the charge pressure? Probably.but how much?1,2,3,psi?

Yep! Exhaust... If you listen near track and tunnel it sounds like a broken carsilencer.Seams to be some serious leaking between 2-2 in the 4-2-2-1 system,that one with some sort of cupperbelts.Impossible to get it tight. Any tips ´n tricks?

Stainless steel ,as hard as possible.

Pulled of the intercooler and a lot of fuel ran out,at least 10 cc. What the #$%&* is going on now? Could it be a RICH condition instead?

Rx-rider:Thanks for the instructions and yes,I glued them but maybe the holes in inserts ended upp wrong in the T:s.one of them didn´t fit in the carb so I had to use a drill. I guess I have to take everything apart again,and another spoiled weekend:( I did a search on leaks/leaking and...

Does anyone no the theory behind this?From what I understand the lower line that goes from the intecooler to the double T:s between carbs,pressurize the floatbowls.forcing more fuel into carbs? The rubber T.s turned out to be without the aluinserts so I installed a pair and now it runs like...

Re: turbos Did you hear it from MCX and Erik himself or is it just badmouthing?

Rev.limiter cutting in ?

You mean that its nothing to worry about?When I blow compressed air in the IC it will leak out in two seconds.

Any luck with the pictures? I guess I have some similar leaking problem.

Try to open fuelcap ,if its not topfilled,to check for a pinched ventline. But maybe you already done that.

Check if ventline from gastank is obstructed,it happened to me twice. First time I almost tore the sled apart,second time I noticed it at once.

While waiting for the oilpump I did some pressure test with soapwater on intercooler and carbs.It turned out that there is some serious leaking between the carbs,just where the throttleaxel goes through all carbs. The Throttleaxel has springs between every carbs and on one place it came a...

Well You were right guys,it was the oilpump.The axel to impeller had seised totaly and therefore the pin had snapped of. Why didn´t the pump get any oil after almost 800 miles?I haven´t done any major wrenching since installing the rearmount. Both hoses were not restricted,oilsupply hose...