I keep blowing the 20 amp mini fuse. I just installed the MCX 180 kit, and I can ride for about 20 miles and then it goes. Replace it and keep going. I am sure its a wire rubbing, but not sure where to start.
680
680
- Joined
- Apr 17, 2003
- Messages
- 5,517
- Reaction score
- 1,375
- Points
- 2,003
- Location
- Menno, SD
- Website
- www.ulmerracing.com
- Country
- USA
- Snowmobile
- 2014 Yamaha SR Viper LTX, 2014 Yamaha SR Viper RTX SE, 2015 Yamaha SR Viper MTX SE 162 (turbo), 2015 Yamaha SR Viper MTX SE 153
- LOCATION
- Menno, SD
- WEBSITE
- www.ulmerracing.com
Look behind the primary clutch where the motor mount bolt goes from the frame to the motor. The FX Nytro models are known to rub the harness through on a little "peg" that sticks out of part of the motor mount on the motor.
Thanks Allen, but everything looked fine. I had a couple wires pulled out of my Roll over valve, Fixed up now!
Thanks
680
Thanks
680
Nytroglycerin
Veteran
do you have an OFT teather kit?? mine is causing the ign fuse to blow.
I blew one on Sun while I was working on my sled I think I hit something I will check it out tomorrow and when I went to unload my sled I had nothing I will be checking it all out tomorrow but Im assuming I blew another one while it was on the trailer? I'll post what I find.
