2010 ltx Yuasa YTX20HL-BS vs YTX20L-BS - Mods required?

Joined
Mar 26, 2017
Messages
152
Reaction score
26
Points
443
Location
Port Perry, Ontario
Country
Canada
Snowmobile
2010 Vector ltx GT
2010 MXZ X 1200
LOCATION
Port Perry
I rode my 2010 Ltx for the first time last night. I pulled it out of the trailer and it was a little sluggish starting in -5 C. I think, before I have an issue starting,I will replace the battery.

The factory battery is YTX20L-BS and, as I understand it, the 20HL is a better alternative. Does it fit directly in the machine or are modifications required. I read something about needing to modify the battery box.

Is this the case or is it a direct replacement?

Cheers and ride safe
 
I just did this yesterday. I had to cut a slot down the negative cable side of the battery cover to allow it to stretch over the 20HL.


Not a big deal, nobody will ever see it anyhow.

Sent from my SM-G930R4 using Tapatalk
 
Sweet, I guess its worth it, This is my first sled without a pull start so my OCD is kicking in thinking about possible battery failures:)

On a side note: do you have the starter stuck warning light installed? I just replaced the starter relay and was thinking about this mod.
 
No I do not. I've thought about putting it on though.

Sent from my SM-G930R4 using Tapatalk
 
My original lasted 7 years. But it cranked a bit slow once last winter, so I didn't wanna push my luck.

I keep my sleds on a tender year around. I believe that helps alot.

Sent from my SM-G930R4 using Tapatalk
 
Yes sir.

Sent from my SM-G930R4 using Tapatalk

Then I suppose I will just go with that one. It is only $79 compared to $137 both. If it lasted you that long it should serve my needs. I normally charge over the summer as well.
 
I changed the battery this year on my 08 and went from the 20L to the 20HL with no battery box modifications. I had the batteries side by side and they are the same dimensions


Sent from my iPhone using Tapatalk
 
I changed the battery this year on my 08 and went from the 20L to the 20HL with no battery box modifications. I had the batteries side by side and they are the same dimensions


Sent from my iPhone using Tapatalk

Yuasa brand again?

Mine was not. Maybe that's the difference??

Sent from my SM-G930R4 using Tapatalk
 
Replaced the original Yuasa YTX20L-BS with the upgraded 330 cranking amps Yuasa YTX20HL-BS and it fits perfect with no modifications required.
 
Replaced the original Yuasa YTX20L-BS with the upgraded 330 cranking amps Yuasa YTX20HL-BS and it fits perfect with no modifications required.
Nice.

I guess that's what I get for saving a buck on a different brand. Oh well, just the cover & the cut I made affects nothing.

Sent from my SM-G930R4 using Tapatalk
 


Back
Top