2017 Sidewinder EPS Install Video and Info

[MrSled]

I would be interested in the harness you built. You mentioned you have a few that may be available?
Thanks!

Ok, I’ll let you know after this weekend how many harnesses I have left. I can always get more plugs and do a few more.

 

[DMCTurbo]

Ok, I’ll let you know after this weekend how many harnesses I have left. I can always get more plugs and do a few more.

I'll take one also.

 

[DMCTurbo]

So the canbus/comms connection plugs into the plug which the flasher plugs into correct?

 

[MrSled]

I'll take one also.

So the canbus/comms connection plugs into the plug which the flasher plugs into correct?

Yes. I had to make a splitter for my 2017 with flasher.

 

[MrSled]

FYI: I have an updated that I added to the first post.

Update 11/5/24: After further review on our new 2025 EPS Sidewinder, you could reduce the size if the main harness wire to 12ga for main power and ground as well as change the trigger power wire to 18GA. I have updated the attachments.

 

[Doc Harley]

Thanks Tom.... Not knocking the video, but I can see this is out of my league. Too bad. Brandon (Fords4life) swears by this EPS kit.

 

[MrSled]

Thanks Tom.... Not knocking the video, but I can see this is out of my league. Too bad. Brandon (Fords4life) swears by this EPS kit.

I have done 8 installs and 2 more scheduled for December. I’m an expert. Lol

 

[Doc Harley]

I have done 8 installs and 2 more scheduled for December. I’m an expert. Lol

Goal for the off-season. Thanks, MrSled

 

[Nytro221]

How do I get a harness?

 

[MrSled]

How do I get a harness?

I may have an extra one to sell. Depends where you are located or you will have to build your own off the directions above. Message me if interested. I only have one left.

I’d build more but would have to have at least 3 people wanting them to make it worth my time to do it.

 

[MrSled]

Here is a splitter that I made if you have a Gap Flasher.

 

[Doc Harley]

Are you planning on stocking and reselling these?

 

[MrSled]

Are you planning on stocking and reselling these?

I have made a few and will make a few more only if I can get a 3-5 order at a time. Or it’s not worth making them for me.

I’d have to sell them for about $50 each plus shipping as well as my full eps & power harnesses are $150 plus shipping.

I know anyone can build them cheaper but I have to do 3-5 at a time to make out on them.

 

[Doc Harley]

I have made a few and will make a few more only if I can get a 3-5 order at a time. Or it’s not worth making them for me.

I’d have to sell them for about $50 each plus shipping as well as my full eps & power harnesses are $150 plus shipping.

I know anyone can build them cheaper but I have to do 3-5 at a time to make out on them.

I completely understand your position. Being able to get these harnesses pre-manufactured takes a bit of the load off the entire job.
Ty...

 

[MrSled]

I completely understand your position. Being able to get these harnesses pre-manufactured takes a bit of the load off the entire job.
Ty...

Right so if we get more interest I’ll make more. Right now I’m out.