Reaper
TY 4 Stroke Junkie
- Joined
- Nov 10, 2005
- Messages
- 667
- Location
- Starbuck, Manitoba
- Country
- Canada
- Snowmobile
- 2014 SR Viper XTX. COTC, Hygear 141 pro link.
Checked my alignment between secondary and primary and I was at the outer limit 61.1 mm.
Spec is 58.1 mm to 61.1 mm. Removed the 1 mm shim from behind the secondary and I am now at 60 mm.
This also brought up by belt height to the bottom of the cog being 1 mm above the sheath (secondary off the machine and fully closed and belt lying in it). With secondary on the machine I probably have 1 mm from sheath to top of the cog on belt.
It ever so slightly creeps on the stand so believe that should be spot on correct?
Spec is 58.1 mm to 61.1 mm. Removed the 1 mm shim from behind the secondary and I am now at 60 mm.
This also brought up by belt height to the bottom of the cog being 1 mm above the sheath (secondary off the machine and fully closed and belt lying in it). With secondary on the machine I probably have 1 mm from sheath to top of the cog on belt.
It ever so slightly creeps on the stand so believe that should be spot on correct?
Last edited:
shagman
Vendor
- Joined
- Feb 18, 2014
- Messages
- 1,059
- Age
- 59
- Location
- Cedarville Michigan
- Country
- USA
- Snowmobile
- 2017 Sidewinder BTX LE
2014 SR Viper XTX SE (Sold)
I would leave it at 61mm from the testing i have done. I also run deflection even with top of secondary. I have found this works better on the new clutches. Track doesnt need to creep.
Reaper
TY 4 Stroke Junkie
- Joined
- Nov 10, 2005
- Messages
- 667
- Location
- Starbuck, Manitoba
- Country
- Canada
- Snowmobile
- 2014 SR Viper XTX. COTC, Hygear 141 pro link.
OK, Thx Shagman.
