clutch set up for 2001 srx 2 stroke

[Slayer]

Hello, I am wondering if someone could get me into the right direction for a snow drags clutching set up on my 2001 srx triple?
Thanks

 

[RobX-1]

You will have better luck posting on the two-stroke side of TY.

 

[DMCTurbo]

8bu-00
W-w-w primary spring
51-43
Green secondary spring

 

[Slayer]

Thanks for your input DMCTurbo, most appreciated. Do you or did you run this set up on an srx in the past?

 

[DMCTurbo]

Thanks for your input DMCTurbo, most appreciated. Do you or did you run this set up on an srx in the past?

Yup. It's been 20 yrs.

 

[Slayer]

Ok wonderful.
I suppose you had very good success with it.
Just to give you some more input to figure out if it will work for me as well:
We can't use studs in the Yukon or northern BC on the drag races. I am about 240 lbs clothed up, 6 foot 2. Elevations we run the drags is usually about 2500.

 

[Slayer]

Also could you recommend a place where I could source these clutch items you recommended?
Thanks

 

[DMCTurbo]

They are all yamaha parts. The helix came on the apex I believe or can be purchased thru Dalton. You are best to go to the 2 stroke side of TY for more info.

 

[Slayer]

Ok thanks, I will move over to the 2stroke side then.
I do appreciate your input though. Gets me a good start.

 

[RobX-1]

 

[Slayer]

View attachment 178335

Thanks for this input as well, very helpful and appreciated.
Big learning curve for me

 

[Slayer]

They are all yamaha parts. The helix came on the apex I believe or can be purchased thru Dalton. You are best to go to the 2 stroke side of TY for more info.

Thanks for this. I already found where I can source the parts. We also have an incredible Yamaha dealer ship here in the Yukon, who are really helpful as well.
May I ask you yet what kind of track your are running on your srx for the drags?
Thanks

 

[maim]

odds are back then was most likely stock yokohama.

 

[74Nitro]

Thanks for this. I already found where I can source the parts. We also have an incredible Yamaha dealer ship here in the Yukon, who are really helpful as well.
May I ask you yet what kind of track your are running on your srx for the drags?
Thanks

I don't know what class you're running in, but if you are non-studded, then you'd want 1.25-1.5 lug height. 1.5 is the most that will fit for clearance.

 

[Slayer]

I am opting for the Camso ICE Attak XT. I think that should work well.