Has anyone added studs to this track thinking about doing it for racing its a 136. I am also thinking about going back to a 121. The xt 136 is a great trail track hate to put holes in it ideas and thoughts
BigDogrx1
TY 4 Stroke Guru
Is that pre-studded, if it is you can't stud that track.
If it's ice ripper it's 1 ply.
Normal track is 2 ply.
If it's ice ripper it's 1 ply.
Normal track is 2 ply.
Yes its pre studded so back to the drawing board
hibshman25
Vendor
- Joined
- Sep 25, 2005
- Messages
- 2,866
- Age
- 41
- Location
- Lebanon, PA 17042
- Country
- USA
- Snowmobile
- 2017 sidewinder ltx dx
2018 snoscoot
It will say on track itself that it can't be studded. I have had ice rippers come in with studs and they have several pullouts. Such a waste of a good track.
Its a great track probably going to pull it after are week trip in 1st part of January and focus on drag racing/ high speed. I still have the 121 track that could be reinstalled
Just because its a single ply does not mean you cannot stud it. You have to use the correct studs. I am running 144 woody's in my single ply at 252 hp with over 2000 miles on it and not 1 pull out.
BigDogrx1
TY 4 Stroke Guru
Well U.S.A. tracks who I bought mine from said DON'T, Since they made and sell it I'll go with what they told me.
Woodys makes a stud called the Grand Master. It is designed for single ply tracks. I have studded my buddy's Doo's which come factory with a Camoplast single ply track.
No issues after 3 seasons.
http://www.woodystraction.com/single-ply-snowmobile-track-grand-master
No issues after 3 seasons.
http://www.woodystraction.com/single-ply-snowmobile-track-grand-master
Last edited:
Studding this track would save me the hassle of switching tracks mid season how many studs would you put in it? Is the question? Was thinking about running a 121 with aggressive ice studs I have a 121 for it. I still have time either way I have to buy studs.
thor452
Because I can
- Joined
- Jan 5, 2010
- Messages
- 3,029
- Location
- Shawano,WI 54166
- Country
- USA
- Snowmobile
- 2012 Apex XTX 2017 Sidewinder LTX-LE
there are a set for sale in the classifieds right now too.
I'm sure you added extra stud protection to your sled when you installed studs I'm sure I will find some info on this after I do a search
When I installed a rear exchanger I needed to add more protection. Was using 1.325 studs in the stock Ripsaw.
Pics here
http://www.ty4stroke.com/threads/rear-heat-exchanger-updated.108028/
Pics here
http://www.ty4stroke.com/threads/rear-heat-exchanger-updated.108028/
Make a mess of that under-tunnel exhaust. I run the Ice Ripper and do just fine as is.Similar threads
