Stubshaft bearing

[rev them up]

Replacing the stub shaft bearing on the Nytro and Sidewinder, local spot doesn't have them, can get them from cat, assuming they are the same bearing and will fit both sleds?

 

[sideshowBob]

Nytro and Sidewinder use the same stubshaft bearing so a 998 bearing for a cat will fit both sleds.

 

[rev them up]

Nytro and Sidewinder use the same stubshaft bearing so a 998 bearing for a cat will fit both sleds.

Thanks.

 

[twyztid]

As far as I know, it should be a 6307-2RS-C3 bearing.

This bearing would likely also be good. The -2RD suffix on the Koyo bearings is a light contact seal which is meant for higher speed applications. This is the type of bearing used for the clutch side jackshaft bearing as well as the jackshaft bearings on the older Japan-built sleds like Apex, Vector, Nytro, etc. It is a Koyo part #6307-2RD (also a C3 clearance bearing).

https://www.motion.com/products/sku/02191181

 

[Turboflash]

Must be C3. Do not use one that isn't.