2011 Nytro XTX bogs down

[JesseD32]

So I am waiting on a new starter solenoid(by the battery) so I’ve been starting it with a screwdriver. I recently had to replace the starter, and instead of waiting for the new solenoid I figured I’d try the old one just to see if it was actually junk. When installed it did nothing, when I tried to jump the terminals it just turned over and wouldn’t fire and then said code 43. So I put my OTHER old shitty one in it and I jumped it and it ran. BUT when I’m on the trails and try to hammer on it at all it bogs down and I can only get about 50-60 mph. If I slowly give it more and more gas it doesn’t big down until about 1/2-3/4 throttle. No codes...Will my new solenoid fix this or is it a different problem? Started doing it a little last year before my solenoid died, was just wondering if maybe the voltage wasn’t good enough for the injectors or fuel pump or something....thanks!!

 

[maim]

was it green around the fuses?

 

[JesseD32]

was it green around the fuses?

There might’ve been a touch of green but nothing crazy, I was just wondering if that would effect the throttle/ bog that it has....I should have a new solenoid tomorrow but wasn’t sure if it was the cause of my sled running like crap past 1/2 throttle

 

[JesseD32]

There might’ve been a touch of green but nothing crazy, I was just wondering if that would effect the throttle/ bog that it has....I should have a new solenoid tomorrow but wasn’t sure if it was the cause of my sled running like crap past 1/2 throttle

Wasn’t sure if the solenoid will fix it or if maybe it’s the crankshaft position sensor is starting to fail but not throwing a code yet.

 

[yam429]

Has the throttle position sensor been messed with?

 

[JesseD32]

No