In MPI's instructions it says on 05 RX's you have to install a M8 washer for the guide pully bracket. Is that on the top mount bolt or bottom? Thanks
obile
Pro
has to be the top one the bottom is an m11 i think itll only fit on the top one.
obile said:
Thanks. After I posted this I thought about it and decided that I'm stupid.
Next. It calls for a 0.0400 thick washer and all I can come up with is a 0.4600. Will this work or should I keep looking?
- Joined
- Apr 17, 2003
- Messages
- 5,347
- Location
- Menno, SD
- Website
- www.ulmerracing.com
- Country
- USA
- Snowmobile
- 2014 Yamaha SR Viper LTX, 2014 Yamaha SR Viper RTX SE, 2015 Yamaha SR Viper MTX SE 162 (turbo), 2015 Yamaha SR Viper MTX SE 153
- LOCATION
- Menno, SD
- WEBSITE
- www.ulmerracing.com
Maddog, if you can not find the correct washer contact MPI about getting one. Make sure you have the correct washer as this is what aligns the supercharger shaft! Very important to use the correct components!
BlgsRX-1mtn
TY 4 Stroke God
- Joined
- Apr 16, 2003
- Messages
- 1,530
- Location
- Billings, MT
- Country
- USA
- Snowmobile
- '03 RX-1 Mountain LE
Srxspec said:
And hope they get it to you before the snow flys. My SC kit was supposed to be for the RX-1 but my Charge tube was for an APEX. I called to ask about the missing brass nipple and hose to pressurize the carbs (difference between the two). Was told it would ship out imediately. One week later still no parts (Bear was going to make them that Fri.) so I went to Ace Hardware and made my own from Tygon tubing from the mower repair shop (note yelow hose in picture) and bought the brass nipple I needed. The parts finally arrived two weeks later.
Jim
Attachments
Similar threads
