Primary roller bushings.

[Motorhead]

15mm gforce best so far and we've tried them all.

Sounds like that brass bushing works best for longevity.

 

[Doowithblue]

I guess so. We tested a set with 3800kms and it wore 2 thou. Barely noticeable.

 

[DMCTurbo]

15mm gforce best so far and we've tried them all.

I have a set waiting to go in once I blow through my TP rollers.

 

[Motorhead]

I have a set waiting to go in once I blow through my TP rollers.

Just priced out a set of stock rollers with the plastic bushings from Yamaha. Ouch!! Thank God for that dealer discount.

How much for the G force rollers?

 

[DMCTurbo]

Just priced out a set of stock rollers with the plastic bushings from Yamaha. Ouch!! Thank God for that dealer discount.

How much for the G force rollers?

115USD shipped. Around 150CDN

 

[Mototown]

What washers are they using with the brass rollers?

 

[DMCTurbo]

What washers are they using with the brass rollers?

The rollers are wider and they supply thinner washers.

 

[Motorhead]

115USD shipped. Around 150CDN

All I see on their site is a 15 MM roller for USD $90.00, and that pic shows them measuring it at 16MM and the bushing looks like fiber and not brass. No mention of the skinny washers!

I must be missing something?

 

[jonlafon1]

I ordered a set. 102 usd to my door. 15mm

 

[Motorhead]

I ordered a set. 102 usd to my door. 15mm

That is some short money for rollers when compared to stock original rollers!

 

[jonlafon1]

That is some short money for rollers when compared to stock original rollers!

Yea and they are a lot better.

 

[KnappAttack]

You can fix all the roller issues once and for all with the old primary from a RX-1, Nytro, or Apex. I couldn't believe it would fix the belt and roller issues my buddy and I had, but it does. Some Winder primaries seem fine, but the ones that are not, this is an issue.

 

[twyztid]

You can fix all the roller issues once and for all with the old primary from a RX-1, Nytro, or Apex. I couldn't believe it would fix the belt and roller issues my buddy and I had, but it does. Some Winder primaries seem fine, but the ones that are not, this is an issue.

I plan on doing exactly that. Picked up a low-mile 2012 Vector primary clutch. Will be swapping everything over to it in the off season and will likely sell the stock Sidewinder clutch (it only has about 750 miles on it).

 

[DMCTurbo]

All I see on their site is a 15 MM roller for USD $90.00, and that pic shows them measuring it at 16MM and the bushing looks like fiber and not brass. No mention of the skinny washers!

I must be missing something?

Definetly brass bushings and washers are included. I know the pic shows 16mm but just a typo I'd guess. I have a pic I'll try and find it.

 

[DMCTurbo]